Published at 18/04/2019 10:27:18 from Buenos Aires, Argentina, 1395 visits.
Project for sale at end of hot rod Ford A Tudor 1930. In the photos it has placed engine and gearbox, but they are not included. The sale consists of frame (unnumbered), original chassis closed internal surfaces, reinforced in all its joints. It was painted silver bilayer. Landing gear Ford Taunus modified in its aesthetics. Suspension ball joints, shocks, brake discs, new grills. Refaced maces (bearings, seals) with 5 holes wheels refurbishing Center Falcon. Zip fasteners of replacement, with ends and new bellows direction. address already mounted and connected. Subtraction cutting spirals to the desired height, and repair the brake calipers (there are two sets of calipers). Central rail with holder abulonable below. Differential rear dana 44 limited-slip (brakes to campaign together) with anchors for suspension. Designed for shock absorbers type coil-overs (should send them to make custom). The differential was installed to the frame by means of the system four-links with panhard bar. 4 sidebars are adjustable and are installed with their new bushings. Bars and already painted differential. Rims (5) Ford Ranger plate practically new. Covers only to roll. Cardan on place. Bodywork (unnumbered). The roof is under 10 cm. both doors operate with their original locks. Structurally repaired. Original naphtha tank is soldo to the body and will vacuum your inside to give greater place in the area of the dashboard of the car. Visor that goes over the windshield to be welded. Lateral loaves for plumbing and welding. I have some glasses, mechanisms power mirrors, handles of doors and glasses. Made the floor structure, not the plating of the front floor. Rear sheet metal floor done and over is galvanized naphtha tank (new custom) with their anchorages. Failure to make the fuel line. Finished body anchors and bolted to the chassis. I have a new one-piece seat (rear of toyota etios). Peugeot 405 internal hanging brake servo. Failure do brake lines and install accelerator pedal. Hand truck type brake pedal to suit. Steering column Dodge, with a provisional maza steering wheel and adapter to be able to move the vehicle. Frame rack stainless steel (details at the bottom). Unarmed guard. Not are the fenders, side skirts, bumpers or holders since it did not use. Framework of original stainless steel radiator (Grill). Some original glass. Optical original stainless steel front set into place. For questions call the published phone. I only sell, I don`t take trade-ins.
Value: USD 4500 (Euros 3974 | Pesos Arg. 263250).-